Performance Analysis of Centrifugal Pump at Different Operating Mode
DOI:
https://doi.org/10.24113/ijoscience.v4i11.170Abstract
The aim of this research is to perform numerical simulation of centrifugal pump and PATs mode to analyse its cavitation characteristics and NPSHr at different operating conditions. It was found that maximum efficiency at design discharge for the PAT is about 2 % less than the efficiency in pump mode. It is observed that the efficiencies increase steadily on increasing the discharge from 8.88 kg/s to 14.8 kg/s. in both pump and turbine mode. Thereafter the rate of increase in efficiency becomes very less when increase in discharge to 17.76 kg/s. Maximum efficiency of 59.49 % being achieved at 14.8 kg/s.
Downloads
Downloads
Published
Issue
Section
License
Copyright (c) 2018 Bhanwar Lal,Dr. T. S. Deshmukh
This work is licensed under a Creative Commons Attribution 4.0 International License.
IJOSCIENCE follows an Open Journal Access policy. Authors retain the copyright of the original work and grant the rights of publication to the publisher with the work simultaneously licensed under a Creative Commons CC BY License that allows others to distribute, remix, adapt, and build upon your work, even commercially, as long as they credit you for the original creation. Authors are permitted to post their work in institutional repositories, social media or other platforms.
Under the following terms:
-
Attribution — You must give appropriate credit, provide a link to the license, and indicate if changes were made. You may do so in any reasonable manner, but not in any way that suggests the licensor endorses you or your use.
- No additional restrictions — You may not apply legal terms or technological measures that legally restrict others from doing anything the license permits.
